Waldorf Q+ User Manual download pdf (Page 105)

Sound Parameters – Effects

Waldorf Q User’s Manual 106

Tap Delay

Like the normal delay the Tap Delay produces echoes of the input signal. You can control volume

and panorama by up to 16 delay steps allowing you to create very complex and rhythmic sound

structures. The Tap Delay is synced automatically to the Q´s tempo. Please refer to the chapter “The

Tempo“ on page 56.

Delay !Feedback

1/4 ! 050.0 %

Delay 1/128...8/4.

Sets the length of the Delay taps in note values. A “t” behind the number means a triplet note value

while a “.” behind it means a dotted note.

Feedback 0…100%

Controls the amount of signal that is routed back into the Delay line. Lower values therefore produce

fewer echoes than higher values.

Swing Factor

050.0 %

Swing Factor 0…100%

Changes the timing of the Offbeat Delay. A setting of 50% doesn´t change the timing while lower or

higher settings spread the delay time forwards or backwards.

Selection and Editing of the Delay Taps

Single taps are chosen with the left display dial while the right display dial change its corresponding

value. You can see the selected tap displayed as a number in the left corner. The current value of this

tap is simultaneously shown in the right display corner. Additionally, a blinking cursor marks the

position of the chosen tap. As you will see, all values are shown in the lower display line. You can

switch between the volume and panorama page with the red dial.

Tap 1: Volume: 6

[7-5-4-6-7-7-6546]

Volume -, 0…7

Determines the volume of the choosen delay tap. A – switches the corresponding step off.

Tap 1: Pan: left

[c-c-c-l-r-l-rrll]

Panorama left / center / right

Determines the panorama or stereo spread of the choosen delay step. In the lower display line you

can change all panorama settings to c (center), l (left) or r (right).

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 170 171

No comments

Waldorf Q+ User Manual Page 105