Waldorf Q+ User Manual download pdf (Page 102)

Sound Parameters – Effects

103 Waldorf Q User’s Manual

Cutoff 0…127

Cutoff

064

Dampens the high frequency output of the Overdrive effect.

 Please note that the setting of the Mix parameter doesn’t affect the strength of the overdrive

effect but only the volume of it. Therefore, you can get a very strong overdrive with a low

volume when you turn up Drive and turn down Mix.

Five FX

This effect type is a combination of five different effects. You can easily use that as a replacement for

one of the above mentioned effect types. The quality of Five FX is the same as if you use an individual

effect, only its parameter set is reduced. The effects and their order is as follows:

• Sample & Hold is a sample rate reduction effect

• Overdrive is the same as the above mentioned effect

• Ring Mod allows to ring modulate the effect input signal with another signal

• Chor/Dlay is a combination of a Chorus and a Delay effect.

 You should turn the Mix control fully up with this effect type because you probably want the

sample rate reduction to process the whole signal. The Ring Mod and the Chor/Dlay effect

have their own mix control.

Sample & Hold 44.1kHz…2.6Hz

Sample & Hold

44.1kHz

Controls the output sample rate. 44.1kHz means that the signal is unaffected while other values

reduce the sample rate of the sound to the respective rate. You will hear a lot of aliasing when you

lower the sample rate but this is great for so-called “lo-fi” sounds.

Overdrive 0…127

Overdrive

064

Controls the amount of distortion of the signal. Please note that the signal might become a little louder

when you increase this parameter.

Ring Mod 0…127

Ring Mod | Source

064 | Aux

Controls the level of ring modulation between the input signal and a second signal that can be chosen

with Source.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 170 171

No comments

Waldorf Q+ User Manual Page 102