Waldorf Q+ User Manual download pdf (Page 116)

Sound Parameters – Arpeggiator

117 Waldorf Q User’s Manual

SortOrder as played / reversed / Num Lo>Hi / Num Hi>Lo /Vel Lo>Hi / Vel Hi>Lo

Sets the order in which the note list is arranged. With this parameter, you can determine how the

notes you originally play are split up for the arpeggio.

• If as played is selected, the notes are sorted in the exact order as you played them. If you

e.g. press E1, G1 and C1, the note list looks exactly like that.

• If reversed is selected, the notes are sorted vice versa to the order in which you played

them. If you e.g. press E1, G1 and C1, the note list is sorted to C1, G1 and E1.

• If Num Lo>Hi is selected, the notes are sorted from the lowest note to the highest note. If

you e.g. press E1, G1 and C1, the note list is sorted to C1, E1 and G1.

• Num Hi>Lo is the opposite of Num Lo>Hi. The example would be sorted as G1, E1 and

C1.

• If Vel Lo>Hi is selected, the notes are sorted from the softest to the loudest velocity. If you

e.g. pressed notes with velocities 64, 120 and 96, the note list is sorted to 64, 96 and 120.

• Vel Hi>Lo is the opposite of Vel Lo>Hi. The example would be sorted as 120, 96 and 64.

Vel Mode !T.Factor

EachNote ! 000

Vel Mode Each Note / First Note / Last Note

Determines how velocity is interpreted in the arpeggio. Note that each arpeggio step might have an

additional positive or negative offset set by the Arp Accent parameter.

• If Each Note is selected, each note of the arpeggio is played back with the velocity that

you originally played.

• If First Note is selected, the first note you played sets the velocity for all arpeggio steps.

• If Last Note is selected, the last note you played sets the velocity for all arpeggio steps.

T. Factor 0…127

Determines how strong the Arp Timing parameter affects an arpeggio step. If T. Factor is set to 0,

the settings in Arp Timing are completely ignored and the arpeggio is played back without any

shuffled timing. Settings from 1 to 127 increase the shuffling of the notes depending on the setting in

the Arp Timing parameter. T. Factor also works on ROM patterns, these are set up with standard

swing rhythm.

Same Note Overlap Off / On

Same Note Overlap

Off

Due to the various Length parameters in the Arpeggiator section, it might happen that two notes

having equal pitch overlap, e.g. when you play only one single note on a 16 beat rhythm with lengths

set to 1/8.

Note that this parameter only affects notes of the same pitches. If you want to control the lengths of

notes of different pitches, use the Length or Arp Steplen parameters.

• If On is selected, the Note Off message of the previous note is allowed to be sent after a

Note On message of the next note with the same pitch. This setting can be nice with

arpeggios triggering sounds with slow attack.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 170 171

No comments

Waldorf Q+ User Manual Page 116