Waldorf Q+ User Manual download pdf (Page 126)

Sound Parameters – Envelopes

127 Waldorf Q User’s Manual

Loop All

The Loop All envelope type is similar to the Loop S1S2 envelope type but it loops through all

envelope stages as long as a note is held. This means that it goes through all envelope stages first and

if it ended with the Release phase, the envelope restarts from zero and goes through all its phases

again. As soon as the note is released, the looping stops and the envelope goes into its Release

phase.

Attack Decay

Sustain

Release

Key pressed Key released

Time

Level

100%

Attack Level

Sustain 2

Decay 2

Loop

Picture 43: Loop All Envelope

Attack 0…127

Determines the attack rate or amount of time it takes for a signal to go from zero to Attack level.

Attack Level 0…127

Controls the level where the Attack phase ends and the Decay phase starts.

Decay 0…127

Determines the decay rate or amount of time it takes for a signal to reach the Sustain level. This

phase is also used in the loop to go from Sustain 2 to Sustain.

Sustain 0…127

As soon as the Sustain level is reached, the envelope proceeds with the second Decay/Sustain pair

as explained below.

Decay 2 0…127

Determines the decay rate or amount of time it takes for a signal to reach the Sustain 2 level.

Sustain 2 0…127

Sets the second Sustain level. As soon as this level is reached, the envelope goes into the Release

phase.

Release 0…127

The Release phase is used while the note is pressed to form the last stage before the loop restarts with

the Attack phase. When the note is released, the loop stops and the Release phase is used to fade the

envelope to zero.

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 170 171

No comments

Waldorf Q+ User Manual Page 126