Waldorf Q+ User Manual download pdf (Page 107)

Sound Parameters – Effects

Waldorf Q User’s Manual 108

LFE LP !Input HP

082.4 Hz |110.0 Hz

LFE LP 10.9Hz...16.7kHz

Determines the crossover frequency below which the effect signal is routed to the LFE channel output

(Sub Out 2 R). If you want to make a typical „5.1 mix“ a setting of 80 Hz is recommended.

Input HP 10.9Hz...16.7kHz

Determines the highpass crossover frequency for all effect signals except for the LFE. The Input HP is

used to adjust the bass frequencies for all channels independently from the LFE channel.

FSL V. !Delay ML

127 | 100.0 %

FSL Volume 0...127

Determines the volume of the effect signal for the left Front Speaker (Main Out L).

Delay ML 0%...400%

Determines the relative delay of the effect signal pertaining to the setting of the Delay parameter.

FSR V. !Delay MR

127 | 100.0 %

FSR Volume 0...127

Determines the volume of the effect signal for the right Front Speaker (Main Out R).

Delay MR 0%...400%

Determines the relative delay of the effect signal pertaining to the setting of the Delay parameter.

CntrS V. !Delay S2L

127 | 100.0 %

CntrS Volume 0...127

Determines the volume of the effect signal for the Center Speaker (Sub Out 2 L).

Delay S2L 0%...400%

Determines the relative delay of the effect signal pertaining to the setting of the Delay parameter.

RearSL V.!Delay S1L

127 | 100.0 %

Rear SL Volume 0...127

Determines the volume of the effect signal for the left Rear Speaker (Sub Out 1 L).

Delay S1L 0%...400%

Determines the relative delay of the effect signal pertaining to the setting of the Delay parameter.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 170 171

No comments

Waldorf Q+ User Manual Page 107