Waldorf Blofeld User Manual download pdf (Page 59)

Sound Parameter

59 Blofeld User´s Manual

Sync off, on

When Sync is set to on, the LFO phases of all voices are

synced so that they sound as one LFO. This can be

interesting when the LFO is applied to modulate Filter

Cutoff or Panning.

When Sync is set to off, the LFOs run independently; this

is better suited for pitch modulation to obtain thicker

sounds.

w Sync does not mean that the LFO is synced to MIDI

Clock or to note start. This is done with the Clocked

parameter or the Phase parameter.

Clocked off / on

When Clocked is activated, the LFO is synced to the

global Tempo of the Blofeld. The LFO Speed setting

changed to offer musically meaningful values.

Start Phase free, 0°…360

Controls the initial phase of the LFO when a new note is

started. Free means that the LFO isn’t restarted on a new

note but runs freely while other values set the LFO phase

to the respective offset in degrees.

Keytrack -200%...+196%

Determines how much the speed of the LFO depends on

MIDI note number. The reference note for Keytrack is E3,

note number 64. For positive settings, the LFO speeds up

on notes above the reference note, for negative settings

the LFO slows down when higher notes are played and

vice versa. A setting of +100% corresponds to a 1:1 scale,

e.g. when the keyboard is played an octave higher, the

LFO speed is doubled.

Delay 0...127

The Delay parameter works in different ways depending

on the setting of the Fade parameter:

• When Fade is set to +00…+63, the LFO signal

output is zero for the time set with the Delay

parameter. After this time, the LFO is faded in and

then runs with full magnitude.

• When Fade is set to –64…-01, the LFO runs with

full magnitude for the time set with the Delay

parameter. After this time, the LFO is faded out to

zero.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 127 128

No comments

Waldorf Blofeld User Manual Page 59