Waldorf MicroWave XT User Manual download pdf (Page 17)

1. First, switch back to program

A001 Saw Repeat WMF

2. Press the Play button 햽 again to access this page. The display then shows 4 sound

parameters that by adjusted directly via the corresponding value dials:

3. Use the value dials to change the sound parameters and listen to the effect on the

generated sound. Actually, you can define the parameter set in this page on your

own. This is described later in the manual.

Comparing edited and original Program

You may always check your modifications against the original version of the program.

Though you can decide whether editing is going the right way or not.

1. Press the Compare key 햹 while holding the Shift key 햽.

2. The MicroWave II/XT/XTk now uses the original parameter values as they were set

before editing was applied. The display also shows these values. Play some notes to

listed to the unedited sound.

3. Press the Compare key 햹 while holding the Shift key 햽 again. This brings you

back to the edited sound program.

Recalling Edits

If you don’t like the changed sound program, you can void the edits at any time and return

to the original.

To do so, press the Recall key 햺 while holding the Shift key 햽.

Storing Programs

After editing the program you have to store it to keep the changes permanent.

1. Press the Store key 햻 while holding the Shift key 햽. The display now shows:

2. Use the rightmost value dial to select a memory location for the edited sound. You

can also leave the setting as it is. In this case you’re going to overwrite the original

sound program. Don’t do it here, we will need it further on in this tour.

3. Press the Store key 햻 while holding the Shift key 햽 again. Your program is now

permanently memorized.

Doing further Edits

We are now moving deeper into the sound editing capabilities of the MicroWave II/XT/XTk.

In the next steps we will show you how specific parameters act on the MicroWave

II/XT/XTk’s behaviour. At first we like to play along with the filter.

1. Switch back to sound program

A001 Saw Repeat WMF

2. Press the second parameter select key 햸. This is the same key that is used for the

Recall function, but in this case, it is used without the Shift key 햽. The display

changes to show the parameter page for Filter 1:

Store Sound A001 A001 ?

Saw Repeat WMF

F1 Cutoff|F1 Reso |F1 EnvAmt|FE Decay

092 | 000 | +29 | 084

User’s Manual MicroWave II • MicroWave XT • XTk

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 125 126

No comments

Waldorf MicroWave XT User Manual Page 17