Waldorf microQ User Manual download pdf (Page 15)

KOMPLEXER Manual EN 15

Bendrange - Range of the oscillator using the pitch bend wheel.

Keytrack - At 100%, the oscillator follows the MIDI notes for each octave at twice the

frequency, which is the standard for most playable sounds. At 0%, it does not change the

pitch depending on the pressed MIDI note (e.g. for drums, effects etc.).

FM - The oscillator can be FM modulated by any source. Select the source from the drop-

down menu under FM and use the slider to control the amount.

Suboscillator - You can mix a square oscillator into the selected waveform. Select the

octave position using the buttons.

OSCILLATOR 3+2

Oscillator 3 does not have any wavetable

waveforms, but can be synchronized with

oscillator 2. You can set the pulse width of the

pulse waveform under PW and modulate it in

the modulation matrix on the MATRIX screen. If

Sync is activated, oscillator 3 is synchronized

with oscillator 2. Experiment with envelope

curves or LFOs in oscillator 2 in order to obtain

typical sync sounds. To do so, oscillator 3 must

be enabled and its level set to > 0 in the mixer.

MIXER

The MIXER mixes together the

oscillator, the ring modulator

and noise. Use the Route

knobs to mix the respective

source to Filter 1 and/or Filter

2. The Color parameter

changes the color of the noise

from brown to white (middle

position) to pink. The two Parallel/Serial filter buttons switch the two filters parallel or in

series. Furthermore, the parameters of the mixer can be changed using the modulation

matrix.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

No comments

Waldorf microQ User Manual Page 15